SKC QuickTake 30 Sample Pump
QuickTake 30 Sample Pump Mold, Bioaerosol, Dust, and Asbestos Sampling,
Fitur:
- Aliran konstan dari 10 hingga 30 L/mnt
- Ideal untuk digunakan dengan
- Penabrak kaskade yang layak termasuk SKC BioStage®
- Kaset perangkap spora seperti VersaTrap®
- Sampler cetakan rongga dinding
- Kaset mikrovakum
- Sampler lain yang membutuhkan aliran hingga 30 L/mnt
- SKC IOM Sampler pada aliran dari 8,2 hingga 10,64 L/mnt
- Waktu jangka panjang
- Pengisi daya/adaptor AC untuk pengambilan sampel yang diperpanjang
- Paket baterai lithium-ion (Li-Ion) isi ulang yang andal
- Kompak dan portabel
- Beratnya hanya 4,8 pon (2,2 kg)
- Pegangan agar mudah dibawa
- Mudah digunakan
- Kontrol keypad besar
- Alarm yang terlihat dan terdengar di akhir siklus
- Tampilan digital kontras tinggi
- Kebisingan rendah — rata-rata < 64 dBA pada 3 kaki (37-mm, filter MCE 0,8-μm pada 16,8 L/mnt)
Ordering Information:
QuickTake 30 requires 3/8-inch ID tubing.
Pump and Kits
QuickTake 30 Sample Pump*† and charger
QuickTake 30 Sample Pump,*† Rotameter, and Charger
QuickTake 30 BioStage Pump*† Kit includes pump, charger, rotameter, Standard
BioStage, mounting bracket with inlet adapter, calibration adapter, and deluxe carry case
Accessories
Charger/Adapter
Mounting Bracket for BioStage includes inlet adapter
Rotameter, for QuickTake 30
Replacement Battery Pack,* Li-Ion
Replacement Filter/O-ring Set includes 5 filters and 1 O-ring
Recommended Accessories
Mounting Bracket for BioStage Impactor
Rotameter
* QuickTake sample pumps contain Li-Ion batteries and are subject to special shipping regulations
† Use in non-explosive environments only. Not UL Listed for intrinsic safety
Note: Replacing batteries with non-approved battery packs voids any warranty..
Spesifikasi
Performance Profile | Quick View | |
Flow Control Accuracy | ± 5% of set-point after calibration | Flow Rate (L/min) |
Flow Rate (L/min) | Flow Rate (L/min) | Flow Rate (L/min) |
5 hrs at 15 L/min with spore trap cassette (VersaTrap)‡ | Weight in Pounds (kilograms) | |
4 hrs at 28.3 L/min with BioStage viable cascade impactor | 4.8 (2.2) | |
Charge Time (varies with battery capacity and level of discharge) | Approximately 5 hrs with approved charge | Compensation Range (inches water) |
Up to 15 at 30 L | ||
Built-in Timer/Clock | ||
Temperature Range | Operating: 32° to 104° F (0° to 40° C) | Constant Flow |
Storage: -4° to 95° F (-20° to 35° C) | Programmable | |
Charging: 32° to 113° F (0° to 45° C) | Flow Fault Feature | |
Operating Humidity | 0 to 95% non-condensing | Battery Type |
Timer Display Range | 1 to 999 min. If run time exceeds 999 min, timer display rolls over and repeats 1 to 999-minute runs until user stops pump or power supply is depleted. | Li-Ion Battery (7.4 V, 10.4 Ah, 77 Wh) and/or AC Adapter |
Flow Fault | If the pump is not able to compensate due to excessive back pressure, a flashing FlOF will appear on the LED. If the fault is not corrected within five seconds, the pump will beep four times and stop running. | Battery Check |
Tubing | ||
Requires 3/8-inch ID tubing | ||
‡ Sampling time is usually ≤ 10 minutes; however, SKC recommends reducing length of sample time when using a 30 L/min flow rate to prevent overloading the media |